Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
When you go to the home improvement store, find out how much 12 gallons of the paint you want would cost, and that will help you determine your cost. Maybe it's a low-quality paint that costs $30, in which case you're looking at about $360 for paint. If you choose high-quality paint that costs around $70, your total paint cost could be closer to $840. Professionals also recommend that you add an extra 10 or 20 percent to your total square footage, depending on the type of siding you have. Some textures require extra paint because they're rough. This is especially true with wood and stucco siding. https://m.youtube.com/watch?v=b6_WEt9k_Hw&feature=youtube_gdata
Alamo took almost 7 hours (with a 3 hour break) and then when they came back they had no instillation (as in our proposal) for the ceiling I had repaired and found out after, that the insurance company never fixed the roof. So for the last three years wet installation removed as much as possible it was covered in plastic with no instillation. Finally....3 Years later We called Alamo Paint contractors and were pleased with the head Forman and took the proposal ( drywall, paint, new instillation, texturing, plus banister repair). Needless today what normally took a three hour job ( from our last experience), took from 9am-4pm. The banister we also had repaired by his assistant was only a 30-40 min job and that was perfectly done. The texture on the ceiling was so-so only because you can see the drywall tape under the paint. I?m having a new painter fix this so it can at least look better then drywall tape showing. Alamo are very nice, good people skills but poor workmanship considering all that happened.
Look for signs of a good contractor.Product knowledge and clear communication are the signs of a good contractor. “Look for a pro who recommends high-quality paints,” says Rance. “They should prioritize finish and durability over speed of application for a long-lasting paint job.” And, notes Bunting, a good contractor will respond to you in a timely manner.
When you refinish your existing cabinet doors, you get a whole new look without the astronomical costs normally associated with a kitchen remodel. It’s a much smarter way to update your space, especially if your cabinets are still in good condition. It doesn’t make sense to throw out perfectly good materials, just because you’re tired of the color.
Painting contractors must also carry out administrative and marketing duties. They prepare final accounts for customers based on the original estimates and any additional work. They analyze the cost of the job compared with the estimate to calculate their profit. They market their business through activities such as setting up websites, asking customers for references or contacting property maintenance companies with details of their services.
While a good painting contractor may tell you he’s insured, a great contractor presents a copy of his policy, proving the amount of coverage he carries for both property damage and bodily injury that may result from the contractor’s work. By nature, paint materials are highly flammable and, should a tragedy occur, you need to know your contractor is sufficiently insured. http://youtube.com/e/b6_WEt9k_Hw
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
Contractors apply several layers of paint to achieve a suitable finish. They leave the first coat to dry for the recommended time and apply one or more finishing coats. They might choose paints with special qualities for different types of room. Manufacturers have developed paints for bathrooms or kitchens that have good resistance to moisture for example. When they have completed painting, they clear away any equipment and restore the area to its original condition.

home Design


Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
There are permanent features of the home that have their own colors which cannot be changed when painting the exterior of the home but can have a dramatic satisfaction level that is experienced when the painting is completed.  Roofing shingles, paving blocks, concrete surfaces, stones and other such features are prime examples of the colors that should be considered when selecting your exterior color scheme for the home.  Homeowners can work off of these colors to make a home that looks uniform and luxurious when the exterior painting is complete.
"Chris and his crew did a great job. The painting of the exterior of our home took a bit longer than promised but the quality was top-notch. Chris was easy to get ahold of whenever we had questions or concerns - which were always promptly addressed. We will be recommending 5 Star Painting of SW Ft Worth to all of our friends and family and will definitely use them again should the need arise."
Most interior painting projects will present corners and edges. Corners, trims, splashes and accents will require cutting in — which generally requires the most patience, preparation and skill. There is a lot of debate among painters whether it is better to cut in before or after applying the roller. Solo painters may want to prepare the surfaces first, apply painter’s tape where required and cut in before applying paint to the rollers. Painters working in teams can split cutting in duties in sections while other team members are applying paint with rollers.
Freshly painted walls often look blotchy. The color is uniform, but the sheen isn’t consistent. This usually occurs over the holes and cracks you patched with a filler or drywall compound. The porous fillers absorb the paint, dulling the surface (a problem called “flashing”). When light hits these dull spots, they stick out like a sore thumb. The smooth patch also stands out in contrast to the slightly bumpy texture of the rest of the wall. A quick coat of primer is all it takes to eliminate flashing and texture differences.
So sad that Angie's List requires the contractor be notified!! They have lost me as a client. If I'm dissatisfied and want to give an "F" rating (question/workers...I SHOULD NOT be intimidated into passing up an opportunity to explain my experience! There is NO WAY my contractor got an Aplus rating from over five hundred people....so someone was lying....yet I can't report that without the contractor knowing it? REALLY?
This is an area that interior painters can easily cut short to save time. Most contracts don't state the extent of the wall repairs included, so it's up to the painter's discretion how much they will do. If it seems like too much work, they'll usually point out the repairs but don't include it in the bid. They'll then ask you if you'd like it fixed after they start your project and let you know how much more it will cost. https://m.youtu.be/b6_WEt9k_Hw
Natalie Miller is the Operations Manager for the Fort Worth Northwest and Southwest Territories.  She holds an associates degree from Brookhaven College. Mrs. Miller is most often the voice you will hear when calling the Fort Worth office. Her goal is to make your experience with Southern Painting one you will happily share with your friends and neighbors.

cost Of Painting


Recently I had the outside of my home painted. The contractor wrote a good contract, but I failed to realize that some things were not in it. It reminds me of the car dealer who offered a good price on a new car but failed to mention that it did not include tires. My contractor failed to specify that lattice under a porch was included. So the painters did not paint it. To his credit, he did instruct them to paint it when I brought it to his attention. If I had the job to do over again I would look for an individual who came with referrals from happy customers rather than a franchise owner..


State your expectations. The number of coats a painter applies isn’t the only factor in determining the quality—and price—of the project. Preparation is also key. If you want a surface that’s free of unevenness from past paint jobs, tell the contractors—and be prepared to pay extra. But if you can live with some imperfections, agree on what level of prep is acceptable and what isn’t.

how Much Does A Paint Contractor Charge

×